Version #3.0.2
- Bug fixing
Version #3.0.0
- Optional Smart Cylinder and Pen Adaptive contact
- Smarter Cylinder
- Pen adaptive contact
- Automatic Calibration
- New LED light communication
Version #2.0.0
- WiFi access point issues fixed
- Smart Cylinder
- New OTA process
Version #1.0.7
- General improvements and optimization
- New memory partition table
Version #1.0.5
- General bug fixing
Version #1.0.4
- Leds blink blue light until the startup is done
- Improved led interface during WiFi configuration
- LEDs blink faster during the connection tentative
- LEDs stay red for 2 seconds in case the connection to the new WiFi is not successful
- Printing and Erasing messages now contain a flag indicating the pause
- LEDs blink purple if the robot is waiting for the ceramic-heater to reach the temperature
- Print and Erase commands now accept a new parameter with the Gcode string to send in case of a soft reset
- Fix some LEDs behaviour
Version #1.0.3
- Fix motors speed
- Improved serial speed
- LED Multithread
- LED working
- Fix contemporary movement Z X & Y
- Removed pause after z-movement
- Hard Stop implemented
- Pause implemented
- Buttons working as planned
- General fixes
- It is now possible to use a line in the topic print in case of a stop
- Changed "Firmware Version" position
Version #1.0.2
- Parametric AP
- Fixed the lock due to the slow process of sending old lines
Version #1.0.1
- Improved serial connection
Version #0.2
- Fix OTA (through Soft AP)
- New platform version